If your car’s shift boot is torn or worn, it’s time to replace it. The process of replacing the boot can be a bit tricky, so make sure you have all the necessary tools and supplies beforehand.
How To Change Shift Boot Honda Civic?
Remove the shift knob by loosening the nut below it. You can remove the shift knob and nut and set them aside by unscrewing them. Stock shift knobs have a plastic trim ring that can be unclipped by pulling it straight down. Once the shift knob is unscrewed, remove it.
The boot should be pushed into the console, and the silver trim piece should be firmly grabbed and pulled up evenly on both sides. You should be able to pop it off quickly.
In order for the boot to be attached to the silver trim piece, four torx head screws are used. By removing the screws, you can pull the boot out of the ring and the boot out of the boot.
A total of six staples are used to attach the boot to the ring. If you use needlenose pliers or anything else that might work, remove them.
Remove the staples holding the boot with a slot screwdriver or small pry tool. Cut the lock tie that holds the boot onto the trim piece once the boot is turned inside out.
Cut the zip tie holding the plastic ring to the boot by turning the old boot inside out and using cutting pliers. The new boot will require this ring.
The top section of your new boot doesn’t have stitching, so turn it inside out and cut it off.
Attach a zip tie or rubber band to the plastic ring from the old boot and wrap the top of the boot around it. Ensure that it is securely fastened.
Follow these instructions in reverse order to install a new shift boot.
Change The Shift Boot Honda Civic
You must remove the shift boot if your Honda Civic has a manual transmission. On most Civics with automatic transmissions, you must remove the gearshift housing for the new boot to fit correctly.
You can find boots and housings at local car dealerships or parts stores. Measure your current shift boot before buying a replacement to get the right size. Once you have purchased and installed your new boot or housing, torque it down firmly using a wrench.
Also, check the fluid that needs to be changed; good fluid will perform better on city highways.
Sandpaper, Loctite 242 Or Equivalent, And Solvent Required
If your shift boot Honda Civic is broken, replace it with a new one. You can do this using sandpaper or Loctite 242 (or equivalent) and the required solvent.
Remember that the longer the job takes, the more likely damages will be incurred to other parts of your car. Use caution when working on your vehicle so that you don’t injure yourself further and have an easier time getting your Honda back on the road as soon as possible.
Be sure to consult with a mechanic if you are unsure how to do these repairs on your own – they may have additional tools or knowledge that could make the process much smoother for you.
Fitting The New Boot With Loctite 242 Secured
If you have a 1996 Honda Civic or newer, the boot may need to be changed. Loctite 242 can be used to secure the new boot in place and prevent it from coming off during future wear and tear.
Before starting the job, you will need essential tools such as a wrench, screwdriver, ratchet set, and torch. Check your civic’s manual for specific instructions on changing the shift boot; most models follow a similar process.
Once you have completed the task, clean all the debris away so your car is ready for its next adventure.
To Recap
Changing a shift boot on a Honda Civic is not as difficult as it may seem, and there are many helpful online resources if you need help. Several companies offer professional installation services for those who want to take the plunge.
Leave a Reply