If you are the owner of a Honda accord and planning to go on a trip soon, you would definitely need to get a trailer to carry all your trip necessities that your car’s trunk cannot carry. But, can you put a trailer hitch on a honda accord?
Yes, you can. Although the Honda Accord is not the best vehicle model for pulling huge things, it can pull smaller trailers and a jet ski. To tie a trailer to it, you’ll have to attach an extra or modified hitch. The fittings are meant to bolt straight into the vehicle’s chassis.
However, when pulling loads that are stronger than the car’s design power capacity, the motor may overheat, causing significant issues. This might also overload the transmission, causing the gears to burn out and necessitating a rebuild.
Thus, when looking for trailer hitches for a Honda accord that does not support heavier loads, look for A-Class models with a receiver of 1-1/4-inches.
We do not wish to bombard you with all this information at the start; therefore, read with us below to learn more about attaching trailer hitches on a Honda Accord.
How to Put a Trailer Hitch on: Step by Step
While different Honda Accord models have different towing capacities and variable ways of putting a trailer hitch on, let’s read how you can put a hitch on your Honda Accord.
Step 1: Lowering the Exhaust
Detach the five rubber hangers located inside and outside your car to lower the exhaust. Secure it with straps to avoid falls and then start the work.
Step 2: Removing the Muffler
Use a 14-millimeter socket on the drill to remove the muffler from the driver’s side. Remove the bolt from the heat shield afterward.
Step 3: Drilling Hole in the Heat Shield
Measure five inches from the corner of the heat shield and mark it forwards, then drill a hole on the mark. Make sure the hole lines up with the frame where the hitch is going to be installed.
Repeat Steps 2 and 3 on the passenger’s side.
Step 4: Lining the Holes
Use a U-haul hitch jack to line up the two forward holes of the hitch with the drilled holes.
Step 5: Drill Holes on the Frame
Then, mark the two rear holes on the hitch to align it with the frame later. Remove the hitch right after. After marking, proceed and drill holes on the frame.
Repeat this step on the passenger’s side again.
Step 6: Placing in Bolts
Use two carriage bolts, longer and- shorter, to insert in the holes of the heat shield on the driver’s side. A reverse fish wire technique is needed to be used to install the bolts.
Make sure you enlarge the holes accordingly before putting the bolts in.
Repeat on the passenger’s side.
Step 7: Installing the Hitch
Bring back the hitch and line it up with the holes on the heat shield and the fish wires.
Step 8: Installing Flange Nuts
Finally, remove fish wires and install flange nuts instead. Tighten the bolts according to the hitch-manufacture specifications and instructions. Use an 18mm socket to do so. Otherwise, it may make rattling noise.
Repeat again on the passenger side.
Step 9: Wrap-Up
Finally, put the muffler back and get the car back to its normal condition.
Then, attach your trailer to the hitch and go camping with your newly attached Honda Accord trailer hitch!
The Bottom Line
Now that all is said and explained, we hope now you can answer your friends when they ask can you put a trailer hitch on a Honda Accord and how. However, we suggest that you take the help of a mechanic when attaching a hitch on your Honda Accord since it certainly is a daunting task.